Balboa Water Group Bathroom Aids 40568 User Manual download pdf (Page 2)

Figure 1

Figure 2

PRESSUREINSTALLATION

Figure 3

Figure 4

Figure 5

Once the heater is installed, operation is totally automatic. The heater will help maintain the temperature of the water

in the bathtub, or increase the temperature of the water in the bathtub at about two to four degrees Fahrenheit per

hour. The heater includes the following components.

THERMOSTAT: The “Smart Thermostat” requires no adjustment and will automatically maintain the temperature

at 102º-104º Fahrenheit. If the bathtub is too warm, simply adjust by adding cold water. See Important Safety

Instructions.

HIGH LIMIT: The heater includes an exclusive “Intelligent High-Limit”. This safety circuit will not “false trip” from hot

tap water. It will only turn the heater off if the thermostat fails. To reset, simply press the red button. If the high-limit

trips frequently, call a service technician.

INDICATOR LIGHT: The light turns on when the heater is operating.

PRESSURE/VACUUM SWITCH: The heater is equipped with a preset pressure or vacuum switch. The pump must

be running with water ﬂowing in the whirlpool to allow the heater to turn on. NOTE: Smaller fractional horsepower

pumps may not activate the heater. Contact your dealer for troubleshooting procedures.

CAUTION

Beforeuseofthepumpandheater,testtheGFCIforproperoperation.•

Thepumpand/orheatershouldturnoffwhentheGFCI“Test”buttonispressed.•

30A 115V

20A 230V

BRANCH

CIRCUIT

15A 115V

10A 230V

BRANCH

CIRCUIT

15A 115V

10A 230V

BRANCH

CIRCUIT

GFCI

BLACK (HOT)

WHITE (COM)

GREEN (GRND)

3 COND

1 2

No comments

Balboa Water Group Bathroom Aids 40568 User Manual Page 2