Balboa-water-group 4 Port Butterfly Jet 10-5000 User Manual download pdf

3 PORT BUTTERFLY JET (P/N 10-5050)

& 2 PORT BUTTERFLY JET (P/N 10-5000)**

Installation Instructions

1. Install the 3 Port Butterﬂy Jet as the ﬁrst jet in the system to allow control of ﬂow to

entire system.

2. Locate a ﬂat surface 4 3/4” in diameter for installing the 3 Port Butterﬂy Jet.

3. Drill hole using a 3 1/4” hole saw at center of ﬂat surface.

4. Apply silicone to wall ﬁtting (#4) threads, ﬁlling grooves, and position in 3 1/4” hole.

5. Place gasket over threads of wall ﬁtting on backside of spa wall; the gasket will be located

between jet back and spa wall. Thread wall ﬁtting (#4) into jet (# 1).

NOTE: If surface of spa is uneven, the gasket may be used on front side between

wall ﬁtting ﬂange and spa surface.

6. Hand tighten wall ﬁtting into jet. Tighten the wall ﬁtting to 10 ft/lbs maximum torque.

**NOTE: If you are using only 2 of the ports on the jet body (1 entrance and 1 exit)

be sure to:

1) Use the ports farthest apart (180°). This will assure minimum hydraulic

loss.

2) Block off 3rd port with 11/2” slip plug.

3) Label on jet body indicates direction water MUST ﬂow.

7. Install Nozzle/Diverter (#2) into jet (#1) through wall ﬁtting, pushing nozzle/diverter into

back of jet. Be sure to align opening in nozzle/diverter with middle port of jet body.

8. Lock nozzle /diverter (#2) into place by threading locking ring (#3) until snug.

9. Slip handle (#5) through wall ﬁtting, lining up cutout at bottom of handle with nozzle

portion of (#2) nozzle/diverter. Press handle ﬁrmly into place; clip must snap into place.

NOTE: Handle may be removed by lifting both clips inward inside handle, while

pulling handle out of wall ﬁtting.

10. With jet in place, plumb dedicated air line in either right or left side 1” socket. Use the 1”

slip plug provided to block off unused socket.

11. Rotate the handle to control direction of the ﬂow.

88-4071, Rev. A June 1, 2009

1 2

3 PORT BUTTERFLY JET (P/N 10-5050)& 2 PORT BUTTERFLY JET (P/N 10-5000)**Installation Instructions1. Install the 3 Port Butterﬂy Jet as the ﬁrst j

Page 2

Part No. 10-5050, 3 PORT BUTTERFLY JETPart No. Description10-5051 3 Port Butterﬂy Jet Body10-5052 3 Port Butterﬂy Jet Nozzle/Diverter10-5004 3

No comments

Balboa-water-group 4 Port Butterfly Jet 10-5000 User Manual