Balboa-water-group Diverter Jet, 3 Port User Manual download pdf

DIVERTER JET 3 PORT

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

The Diverter Jet 3 Port valve must be the FIRST jet in the plumbing system to act as a valve. 1.

Locate and cut a 3-1/8 in. hole in the spa wall. Be sure the area located is ﬂat and spa laminate thickness is uniform. 2.

Insert wall ﬂange through hole. Use gasket supplied between ﬂange and spa wall. 3.

Apply sealant to back side of spa and into threads of ﬂange. Avoid getting sealant on gasket. 4.

Install body assembly on to ﬂange and tighten to seal. DO NOT OVER TIGHTEN. 5.

Make all solvent welded connections using PVC to PVC solvent cement according to cement manufacturer’s instructions. 6.

Do not allow cement to come into contact with internal parts of valve. To prevent this, use glue sparingly on sockets.

CAUTION

This is a PVC to PVC connection. Improper gluing or improper cement selection can cause leaks at glued

connection, which can result in property damage.

99201800 Rev. A October 15, 2009

Figure 1

Insert barrel assembly into body assembly rotating back and forth until it bottoms out and snaps into place. 7.

The 3 Port Diverter Jet will permit water from the pump to be diverted to 4 separate modes: 1) position A in spa; 2) 8.

positions A & B in spa; 3) position B in spa; and 4) whirlpool jet. The modes are changed by turning the scallop ﬂange in

either direction. There is no off position.

Item Part No. Description

1 467211XX Barrel Assy.

2 47243500 Flange

3 47224000 Gasket

4 46721000 Body

Following these recommendations will provide trouble free operation of the diverter 3 port jet.

If you have application questions, please

call (714) 384-0384.

SAVE THESE INSTRUCTIONS

DIVERTER JET 3 PORT IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS The Diverter Jet 3 Port valve must be the

No comments

Balboa-water-group Diverter Jet, 3 Port User Manual