Balboa-water-group Stand Alone Quiet-Flo Blower - 4 Buttons User Manual

Browse online or download User Manual for Accessories for water Balboa-water-group Stand Alone Quiet-Flo Blower - 4 Buttons. Balboa Water Group Stand Alone Quiet-Flo Blower - 4 Buttons User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
4 Button Bath Control
Blower
Light
Increase Speed
Reduce Speed
Stand-alone Blower, Light, Speed Buttons
Please see reverse side for more information.
Blower
Speed
If the Blower is off, press the Blower button once to turn the Blower On at
its highest speed, or
Press and hold the Blower button. If off, the Blower starts up at low speed,
ramps up to highest speed, then ramps down to lowest speed. The action
then repeats. Release on the desired speed. If you press and hold the
Blower button again, it continues to ramp repeatedly.
If the Blower is on, press the Blower button once to turn the Blower Off.
Modes
Press the Blower button twice to put the Blower in Pulse mode, or
Press the Blower button three times to put the Blower in Wave mode.
Light
If you have a light installed, the light can be controlled independently of all
other features.
Some lighting options have unique operation for color changes.
See the manual for any special light system that may be installed.
Increase/Reduce Speed
Press and hold the + or - button to increase or decrease the speed smoothly.
Power Up
Upon power up, the LEDs flash as
the bath control goes through a self
diagnostic check. Once the LEDs stop
flashing, you may use the control.
Session Timer
Turning on a device starts a Session
Timer that lasts for 30 minutes.
When all devices are turned off,
either manually or when Session
Timer expires, the previous state can
be restored by pressing the Blower
button within 5 seconds.
Optional Heated Quite-Flo Blower
Any time the blower turns on, the
heater turns on with it.
Control Panel
(90013)
7 LED Bulb Cluster
(59007-V)
Light Adapter Cable
4 Pin Din to 2 pin Amp plug
(25750)
Cable Bath 8 Pin
Mini Din 6ft
(25569)
2” Bath Light
(59200, Front Access)
8' Water
Detect Cable
(99742)
(Optional)
Blower 600w Htr 115v 3spd
(8141-6320)
Bulb Holder with
2 pin Amp plug
(59102)
Page view 0
1 2

Summary of Contents

Page 1 - 4 Button Bath Control

4 Button Bath Control BlowerLightIncrease SpeedReduce SpeedStand-alone Blower, Light, Speed ButtonsPlease see reverse side for more information.Blower

Page 2 - Purge Cycle

LED MessagesLED DefinitionPurge CycleA Purge Cycle removes standing water from the plumbing and dries the air UÊdelivery system. This helps maintain a

Comments to this Manuals

No comments