Balboa-water-group Thera'ssage 16-5550 User Manual download pdf

THERA'SSAGE INSTALLATION INSTRUCTIONS

Locate on a FLAT surface with minimum measurements of 7-5/8," dia. Cut a 6" dia. hole in the center of the 1.

ﬂat area.

Place the outer canister (#5 in exploded view) in hole, with the "Top" at the top of the hole. Mark screw holes 2.

on tub.

Drill #8 holes (3/16" diameter) for each screw to be used to mount canister to spa. 3.

Apply a generous amount of silicone on back of ﬂange and in screw holes. 4.

Push canister through hole from inside of tub with "Top" at top of hole. 5.

Put silicone around the hole, on back of spa. 6.

Put gasket over silicone on back of spa. 7.

Put backing plate (#6 in exploded view) over gasket. 8.

Install screws (#4 in exploded view) in pattern shown below, tighten until snug. 9.

Tighten all screws an additional 1/4 turn in the pattern shown below. 10.

Install jet with air line up, by gluing it onto outer canister using PVC cement. 11.

NOTE: DO NOT overtighten screws.

You will damage the Thera’ssage.

If pressure test is desired use HAl part 16-5505 making sure all silicone and glue joints have had ample time to 12.

cure.

Install ﬂow path (#2 in exploded view) in unit by twist-locking retaining ring into inner canister (#3) 1/4 turn 13.

clockwise.

Install inner canister and ﬂow path into canister in spa wall by pressing until snug and tops of inner canister 14.

and canister in spa are ﬂush. (NOTE: BE SURE TIMING TAB ON INNER CANISTER LINES UP WITH

“TOP” OF CANISTER IN SPA.)

Place grate on front of canister making sure pin in ﬂow path (#2) locates inside brown circular track at front of 15.

grate (#1). This is VERY IMPORTANT. IF THE PIN IS NOT IN THE BROWN TRACK AT THE CENTER

OF THE GRATE, THE FLOW PATH WILL NOT OPERATE. The word “TOP” on the grate must align with

the word “TOP” on the canister.

Fasten grate to canister by lining up tabs on the canister with notches on grate and rotating 1/8 turn clockwise. 16.

1 2

THERA'SSAGE INSTALLATION INSTRUCTIONS Locate on a FLAT surface with minimum measurements of 7-5/8," dia. Cut a 6" dia. hole in the cent

Page 2

PART # DESCRIPTION #1 16-5513 THERA’SSAGE GRILL ASSEMBLY #2 16-5560 THERA’SSAGE FLOW PATH ASSEMBLY #3 16-5521 THERA’SSAG

No comments

Balboa-water-group Thera'ssage 16-5550 User Manual