Balboa-water-group 1 Slimline Air Control 10-2330 User Manual download pdf

1” SLIMLINE AIR CONTROL INSTRUCTIONS

10-2310 & 10-2330

The correct hole size for the 1” Slimline Air Control is 1-3/4”.

1. Before drilling a hole for air control make sure surface is ﬂat, so the Slimline Air Control will have the best surface

to seal against.

2. Drill a 1-3/4” hole.

Align window on the handle (#7) with the “MIN” position. Place the palm of the hand against the top of the

Slimline Air Control handle (#7), and press down ﬁrmly, rotating the handle counterclockwise about a quarter turn.

4. Grasp the outer edges of the handle with your ﬁngertips and pull the handle from the outer body (#3). Remove check valve

ball (#4) from outer body (#3).

5. Place silicone on backside of ﬂange of outer body (#3) and install through hole in spa/bathtub.

88-2310 Rev C June 16, 2009

6. Place gasket (# 2) onto body on the outside of spa wall.

7. Hand tighten nut (# 1) onto body.

8. Glue 1” pipe in socket of air control.

IMPORTANT: MAKE SURE CHECK VALVE BALL (#4) WAS REMOVED TO AVOID

EXCESS GLUE FROM INTERFERING WITH CHECK VALVE OPERATION.

9. Remove excess silicone from around ﬂange of air control and surface of spa/bathtub.

10. Once glue is dry reinstall check valve ball (#4).

11. Make sure handle/stem assembly (#8) is in the fully closed position by aligning the window on the

inner body (#5) and making sure the foam is not showing. Insert handle/stem assembly (#8) into

outer body (#3) with the window on the handle (#7) in the “MAX” position.

12. Once the handle/stem assembly (#8) is in the outer body (#3), press on the top surface of the

handle (# 7) ﬁrmly and rotate the handle clockwise until it stops (approx. 1/4 turn).

13. Check the MAX and MIN position through the window on the top of the handle, and match

with the operation of the jets. If aeration occurs in the “MIN” position, the Slimline Air Control

has been improperly assembled. To correct, press down ﬁrmly on the handle and rotate again

clockwise. Recheck the “MAX/MIN” position with the operation of the jets.

**D0 NOT USE ANY TYPE OF PETROLEUM BASED LUBRICANTS ... THEY WILL DAMAGE THE PRODUCT.

#1 10-3706 NUT

#2 10-3705 GASKET

#3 30-2316 SLIMLINE OUTER BODY

#4 30-2315 SLIMLINE CHECK VALVE BALL

#5 30-2313 SLIMLINE INNER BODY

#6 30-2314 SEAL

#7 30-2311 SLIMLINE HANDLE W/ROTOR

#8 10-2319 SLIMLINE STEM ASSEMBLY

1” SLIMLINE AIR CONTROL INSTRUCTIONS 10-2310 & 10-2330 The correct hole size for the 1” Slimline Air Control is 1-3/4”. 1. Before drilling a hole

No comments

Balboa-water-group 1 Slimline Air Control 10-2330 User Manual